April 19 2010
Nintendo “True-Flat™” T-molding Reproduction… Pre-Order Now!
Tagged Under : Arcade, Donkey Kong, Donkey Kong 2, Donkey Kong Jr., Donkey Kong T-molding, Nintendo, Reproduction, T-molding
True Flat Nintendo T-molding going into production within the next two weeks. This could be your only chance to get on board so get your pre-orders in now.
Details as follows.
1) Flexible PVC Material
2) Exact Shape to the original
3) White
4) Satin finish (not semi-gloss because they cannot do semi-gloss in flexible PVC)
5) Centered (This is NOT offset T-molding)
6) Approx. 15mm wide
PRE-ORDER SPECIAL – ORDER BETWEEN APRIL 19TH and MAY 3rd, 2010 and get Free Shipping in 48 states!!! So, $30.00 shipped for 20 feet worth (One Machine).
NOTE: If you’ve already pre-ordered expect a refund for the difference. If you are outside the 48 states feel free to pre-order then contact me for a proper shipping quote.
Price after May 3rd, 2010 will be $27.50 + $7.50 S/H (Continental USA) for 20 feet (One Machines Worth) and $27.50 + $2.50 S/H (Continental USA) for each additional set. If you are located in Alaska, Hawaii or Outside the continental USA contact me for a shipping quote.
Update: PRE-ORDERS ARE NOW CLOSED. After all pre-orders are shipped I should have extra T-molding so please contact me to get on the list.
“PLEASE NOTE: If your cabinet mating surface is not flat, the slot is damaged, or has irregularities/damage from wear or abuse….the flat T-molding will follow whatever profile exists. It is recommended you correct these problems before installing the T-molding.”
To get the best installation of the “TRUE FLAT T-MOLDING” it is recommended.
(1) Make sure your mating surface is flat, smooth and clean of any debris.
(2) If the mating surface isn’t flat or smooth, it is recommended that you use a sanding block and “slowly” smooth it out. (Please Note: If you have applied vinyl to the sides it is not recommended that you sand the mating surface)
(3) On the flat cabinet sections use a clean/straight/smooth piece of wood and a rubber mallet to install. Taking care to set the molding continuously at the same height (once again material will follow imperfections in your cabinet if you are too aggressive).
(4) To create perfectly smooth inside and outside radii you may have to remove a section of the barb.
[…] Bill offered a pre-order deal to get a set for $30 shipped, but as of this writing that deal is over. You can still purchase a set for $35 shipped (Continental USA). For repro project with low volume, you will usually see a 35-50% premium. If you were to buy a set of molding from most outlets it will run you $25 approx. $35 for a limited run project is an awesome price. Buy Authentic Nintendo T-Molding Today at Chompingquarters.com […]
[…] several freelance projects, Nintendo T-molding, opening my online store and life got in the way of vectorizing the CPO. Then a couple of weeks ago […]